Fall Protection Requirements For Bucket Trucks

In august 2011 osha issued an memorandum regarding fall protection on aerial lifts during construction activities.

Fall protection requirements for bucket trucks.

It s as simple as that. Do not use planks ladders or other devices as a working position. Several osha regulations can and do apply to fall protection for trailers and trucks. Fall arrest systems used in construction work a device that permits an arrested fall is considered a fall arrest system.

Critical components are those in which a failure would result in a free fall or free rotation of the boom. Use a body harness or a restraining belt with a lanyard attached to the boom or bucket. Well to be blunt it is what is says it is. It applied an osha requirement not previously used for aerial lifts.

On bucket trucks osha requires a full body harness and lanyard or a restraining device to prevent falls. Since most frame scaffolds are between 6 and 10 tall this allows users to not have to worry about fall protection every time they set up a single bay or. According to subpart l of the construction regulations specifically 1926 451 g 1 fall protection on scaffolding is not required until you are greater than 10 off the lower level. Stand firmly on the floor of the bucket or lift platform.

All fall protection plans must be prepared and approved by a qualified person and also re approved by a qualified person if anything in the protection plan changes. And it can save your life that s what it can do for you. To help keep workers inside guardrails osha allows restraining devices with a 2 ft. When working in aerial lift or boom type platforms including scissor lifts and bucket trucks the worker must either have a guardrail system in place where applicable or be tied off.

Ensure that access gates or openings are closed. However one specific regulation is broad and encompasses a wide range of applications and instances. It is this particular gotcha regulation where emphasis could be applied to trucks and trailers. Be sure proper personal fall protection is provided and used.

Do not climb on or lean over guardrails or handrails. So why then. Since construction workers in bucket trucks scissor lifts and boom type elevating work platforms are on a horizontal surface a positioning device may not be used for those workers. The provisions of the american national standards institute standard ansi a92 2 1969 section 4 9 bursting safety factor shall apply to all critical hydraulic and pneumatic components.

Fall protection what is and what can it do for you.